Painting Miniatures for Beginners at the Kitchen Table
Most people who start painting miniatures buy a box of figures for a board game they love, open the paints, and spend an evening on one model that ends up looking like it was dipped in yoghurt.

Most people who start painting miniatures buy a box of figures for a board game they love, open the paints, and spend an evening on one model that ends up looking like it was dipped in yoghurt. The detail on the sculpt disappears under thick coats, the face is a single beige blob, and the second figure in the box sits untouched for six months. I know because I still have that first goblin on a shelf, and it still looks surprised to be there.
The gap between that first figure and something you are happy to put on the table is smaller than it looks. It mostly comes down to three habits, a short list of supplies, and choosing the right first model. None of it needs a dedicated hobby room. A corner of the kitchen table, cleared for an hour on a weeknight, is how most painters I know actually work.
Why the first figure goes wrong
Paint straight from the pot is too thick for miniatures. Model paints are designed to be thinned, and when they are not, each coat fills in the tiny recesses that hold the detail: the folds of a cloak, the rivets on armour, the line between lips. Two or three coats of unthinned paint and a 28 millimetre figure loses most of what made it interesting.
The second problem is no primer. Paint on bare plastic beads up and rubs off where your fingers hold the model. A thin primer coat gives the paint something to grip and makes the colours sit evenly.
The third is starting with the wrong figure. Board game miniatures are usually cast in a soft, slightly bendy plastic with shallower detail than hobby models, which makes them harder to paint well, not easier. And people tend to pick the hero character first, the one they care about most, which puts a lot of pressure on a figure painted before they have any practice.
What you actually need to buy
You can spend a fortune on this hobby. You do not need to at the start. The kit below came to about $45 when I last priced it, and most of it lasts for dozens of figures.
- A can of spray primer in grey or white, around $12 to $18. Grey is the most forgiving.
- Six to eight acrylic paints. Brands like Vallejo, Army Painter, and Citadel all work. Start with black, white, a red, a blue, a brown, a skin tone, a metal colour, and a green.
- Two brushes: a size 1 for most work and a size 0 for details. Synthetic is fine. Skip the tiny 5/0 brushes until you have a reason for them.
- A wet palette, which you can make from a plastic food container, a damp sponge cloth, and a sheet of baking parchment. It keeps paint workable for hours instead of minutes.
- A pot of water, some kitchen roll, and a cork or old pill bottle to stick the figure onto, so you are holding the handle instead of the model.
One extra worth considering is a wash, a thin dark liquid that runs into the recesses and adds shading in one step. A single pot of a brown or dark wash costs about $8 and does more for a beginner's figure than any other product.
If you are trying to keep the budget tighter than that, the ideas in starting a craft hobby without spending much on equipment apply here too, especially the advice on buying a starter set instead of individual items.
A first session, start to finish
Pick a simple figure: a basic soldier, a zombie, or a skeleton. Skeletons are a favourite first model for good reason, since the detail is deep and forgiving, and a wash does most of the work.
Prime the figure outdoors or by an open window, in short bursts from about 20 centimetres away, and let it dry for at least an hour. Then glue it to your cork or bottle with a dab of poster tack.
Thin each paint on the palette with a little water, until it looks like skimmed milk rather than yoghurt. Paint the largest area first, such as the cloak or the skin, with two thin coats instead of one thick one, letting each dry for a few minutes. Then move to smaller areas: belts, weapons, boots. Do not worry about tiny mistakes; you will cover most of them later.
Once the base colours are dry, brush the wash over the whole figure and leave it alone for 20 minutes. When it dries, take the original base colours, slightly lightened with a touch of white, and paint them only on the raised edges: the top of the shoulders, the knuckles, the edge of a blade. This is called highlighting, and even a rough version makes the figure look finished.
Paint the base a single earthy colour. That is it. A first figure painted this way takes roughly two hours across two evenings.
Ignore the advice to paint slowly and carefully
Beginners are often told to take their time and get each figure right. In my experience that is the fastest route to giving up. Spending eight hours on one figure means a single bad result feels like a wasted week, and the next model starts to feel like a chore.
I would paint quickly and in batches. Prime five figures at once, base coat them all in the same session, wash them together. You learn more from five rough figures than from one careful one, because each pass teaches you something about thinning, coverage, and where the wash pools. My tenth figure looked dramatically better than my first, and that came from repetition rather than patience.
This is also why board game players often make good painters once they start. Most game boxes come with batches of identical troops, which is exactly the practice structure you want. Paint the twelve rank and file figures first, and leave the hero for when you have had some practice.
Keeping the hobby going in a small space
Storage matters more than people expect, because a hobby you have to unpack for twenty minutes gets skipped. A shallow plastic tray or a cutlery drawer organiser holds paints, brushes, and the palette, and can be lifted off the table in one go. I also keep a shoebox for figures in progress, lined with a sheet of foam so they do not chip.
Ventilation is the other consideration. Spray primer needs fresh air; brushing acrylics indoors does not. If you are working in a flat, the tips in starting a model kit hobby in a small flat cover cutting mats, lighting, and where to prime when you have no garden.
This week, pick one cheap figure and prime it. That single step is what separates the people who paint from the people with an unopened box. Other low cost pastimes worth a look are gathered in the creative hobbies section.
FAQ
What paint do you use for miniatures?
Water based acrylic model paints, such as Vallejo, Army Painter, or Citadel. Craft acrylics work in a pinch but are thicker and cover detail more easily.
Do I need to prime miniatures before painting?
Yes. A thin coat of spray primer helps paint stick and stops it rubbing off where you handle the figure.
How long does it take to paint a miniature?
A simple figure painted at a basic level takes around one to two hours. Detailed display pieces can take much longer.
Is miniature painting an expensive hobby?
It can be, but a starter kit of primer, eight paints, two brushes, and a wash costs around $45 and lasts for dozens of figures.
More in Creative Hobbies
Creative Hobbies
Visible Mending as a Hobby That Saves Real Clothes
There is a navy lambswool jumper in a cotton bag at the bottom of my wardrobe.
Creative Hobbies
Starting a Retro Handheld Collecting Hobby on a Budget
A Game Boy Pocket turned up in my parents' loft two summers ago.
Creative Hobbies
Knitting for Beginners With One Pair of Needles
You want a hobby you can pick up in the evening without a screen, and knitting keeps coming up.